Effect of pulsating water jet processing on erosion grooves and microstructure in the subsurface layer of 25CrMo4 (EA4T) steel

0570499 - ÚFM 2024 RIV CH eng J - Článek v odborném periodiku
Chlupová, Alice - Hloch, Sergej - Nag, A. - Šulák, Ivo - Kruml, Tomáš
Effect of pulsating water jet processing on erosion grooves and microstructure in the subsurface layer of 25CrMo4 (EA4T) steel.
Wear. 524-525, JUL (2023), č. článku 204774. ISSN 0043-1648. E-ISSN 1873-2577
Grant CEP: GA ČR(CZ) GA23-05372S
Institucionální podpora: RVO:68081723 ; RVO:68145535
Klíčová slova: Pulsating water jet * EA4T steel * Erosion * Microstructure * Subsurfae damage
Obor OECD: Materials engineering; Mechanical engineering (UGN-S)
Impakt faktor: 5, rok: 2022
Způsob publikování: Omezený přístup
https://www.sciencedirect.com/science/article/pii/S0043164823001576?via%3Dihub

The erosion of 25CrMo4 (EA4T) steel was studied to determine the surface and subsurface damage due to the high-frequency impingement of water droplets using an ultrasonic droplet generator. The material under investigation is railway axle steel, where the pulsating water jet can be used as a surface treatment method to increase the fatigue resistance. The surface processing is related mainly to standoff-distance which was changed to explore the effect of pulsating water jet while the other parameters were kept constant. Surface and subsurface conditions of the material were analyzed by means of light microscopy, scanning electron microscopy and transmission electron microscopy. By altering the standoff distance, it is possible to investigate droplet impingement from the point of view of the pulsating water jet process for different purposes, such as for maximal erosion or for an increase of fatigue resistance by introduction of severe plastic deformation to the surface. The maximum erosion state was reached for a standoff distance of 35 mm when a crater depth of 750 μm and a width of 1500 μm was observed. The mild conditions, when only plastic deformation is reached occurred at a standoff distance of 21 mm. The occurrence of subsurface cavities in materials with higher hardness indicates a significant penetration ability of the periodic high-density action of water droplets at subsonic speeds.
Trvalý link: https://hdl.handle.net/11104/0342379