Počet záznamů: 1

Visualization of the Evolution of the Fracture Process Zone in Sandstone by Transmission Computed Radiography

  1. 1.
    0475785 - UGN-S 2018 RIV NL eng C - Konferenční příspěvek (zahraniční konf.)
    Vavro, Leona - Souček, Kamil - Kytýř, D. - Fíla, T. - Keršner, Z.
    Visualization of the Evolution of the Fracture Process Zone in Sandstone by Transmission Computed Radiography.
    Procedia Engineering - ISRM European Rock Mechanics Symposium EUROCK 2017. Elsevier Ltd., 2017 - (Koníček, P.; Souček, K.; Konečný, P.), s. 689-696. 191. ISSN 1877-7058.
    [ISRM European Rock Mechanics Symposium EUROCK 2017. Ostrava (CZ), 20.06.2017-23.06.2017]
    Grant CEP: GA MŠk(CZ) LO1406; GA MŠk ED2.1.00/03.0082; GA ČR(CZ) GA16-18702S; GA ČR(CZ) GA15-07210S
    Institucionální podpora: RVO:68145535
    Klíčová slova: fracture process zone * fracture toughness * Chevron Bend (CB) test * glauconitic sandstone * X-ray radiography
    Kód oboru RIV: DB - Geologie a mineralogie

    The article deals with the use of computed X-ray radiography to visualize the development of the fracture process zone in the rock samples. For radiographic observations during the three-point bending loading, glauconitic sandstone from the Řeka quarry (sometimes also referred to as Godula sandstone) was used. The chevron-notched cylindrical specimens with the diameter of 29 mm and 120 mm nominal length were prepared from the sandstone blocks. These specimens were subjected to the Chevron Bend (CB) test carried out in accordance with the ISRM suggested methodology; the span was 94 mm. The evolution of the fracture process zone was continuously scanned using X-ray radiography during the realized Mode I fracture toughness tests (FTT). The scanning was conducted using an industrial X-ray micro-tomographic inspection system equipped with a flat panel X-ray detector of 4,000 × 4,000 pixels and micro-focus X-ray source with reflection target, which are very suitable for obtaining highly detailed radiographic images during the FTT tests. Three-point bending tests were carried out using an in-house designed table-top loading device, construction of which allows precise control of the loading during testing. Continuous X-ray examination and subsequent radiographic image analysis enable investigation of the crack initiation and the process zone development during FTT and represents a useful tool for a better understanding of failure behavior of the rock material during the loading process.
    Trvalý link: http://hdl.handle.net/11104/0272416
    Název souboruStaženoVelikostKomentářVerzePřístup
    UGN_0475785.pdf01.3 MBVydavatelský postprintpovolen