Počet záznamů: 1

Comparison of WSP and HVOF Sprayed Alumina Coatings Behavior during Mechanical Loading

  1. 1.
    0352072 - UFP-V 2011 RIV SK eng C - Konferenční příspěvek (zahraniční konf.)
    Pejchal, V. - Mušálek, R. - Matějíček, Jiří
    Comparison of WSP and HVOF Sprayed Alumina Coatings Behavior during Mechanical Loading.
    Vrstvy a povlaky 2010. Trenčín: LISS a.s, 2010 - (Šošovičková, J.), s. 69-74. ISBN 978-80-970514-2-6.
    [Vrstvy a povlaky 2010. Rožnov pod Radhoštěm (CZ), 04.10.2010-05.10.2010]
    Grant CEP: GA MŠk ME 901
    Výzkumný záměr: CEZ:AV0Z20430508
    Klíčová slova: thermal spray * WSP * HVOF * alumina * 4PB * SAR
    Kód oboru RIV: JK - Koroze a povrchové úpravy materiálů

    In this study, alumina coatings were deposited using water stabilized plasma (WSP) and high-velocity oxy-fuel (HVOF) process with two different spraying setups. Different deposition conditions resulted in different pores and cracks morphology and, for one HVOF setup, in creation of deliberately introduced vertical macro-cracks. Coated samples were subjected to four-point bending (4PB) test. Slurry abrasive response (SAR) test, corresponding to ASTM G75-01, was carried out to compare coatings wear resistance. The microstructure of the samples was observed in SEM on cross-section and free-surface before and after wear test. In addition, coating hardness was determined on the cross-sections. Relation between microstructure features and macroscopic mechanical properties of the coatings is discussed. Tests carried out for coatings with the same chemical composition but different microstructure proved strong dependency of coatings mechanical properties on voids morphology.
    Trvalý link: http://hdl.handle.net/11104/0191667