Počet záznamů: 1
Fabrication of Al-Based Composite Extruded Plates Containing Cellulose Nanofibers and Their Microstructure and Mechanical Properties
- 1.
SYSNO ASEP 0564387 Druh ASEP J - Článek v odborném periodiku Zařazení RIV J - Článek v odborném periodiku Poddruh J Článek ve WOS Název Fabrication of Al-Based Composite Extruded Plates Containing Cellulose Nanofibers and Their Microstructure and Mechanical Properties Tvůrce(i) Lee, S. (JP)
Watanabe, S. (JP)
Tsuchiya, T. (JP)
Mikmeková, Šárka (UPT-D) RID, SAI, ORCID
Müllerová, Ilona (UPT-D) RID, SAI, ORCID
Ono, Y. (JP)
Takaguchi, Y. (JP)
Ikeno, S. (JP)
Matsuda, K. (JP)Celkový počet autorů 9 Zdroj.dok. Materials Transactions. - : Japan Institute of Metals and Materials - ISSN 1345-9678
Roč. 63, č. 11 (2022), s. 1590-1596Poč.str. 7 s. Forma vydání Tištěná - P Jazyk dok. eng - angličtina Země vyd. JP - Japonsko Klíč. slova aluminum ; cellulose nanofiber ; composite materials ; extrusion ; microstructure Vědní obor RIV JA - Elektronika a optoelektronika, elektrotechnika Obor OECD Materials engineering Způsob publikování Open access Institucionální podpora UPT-D - RVO:68081731 UT WOS 000884820800003 EID SCOPUS 85141883651 DOI 10.2320/matertrans.MT-M2022107 Anotace CeNF/Al-based composites were prepared using CeNFs collected by a non-woven aluminum filter, followed by hot extrusion to obtain plates. Gel-like CeNFs were collected by an aluminum non-woven filter and compacted by a warm press to obtain a compressed form with a lighter specific density than pure aluminum. The compressed forms were hot extruded to fabricate bars and plates. Both bars and plates were observed in the macro-and microstructural morphology and XRD measurements. They were not significantly carbonized to graphite only, which was inferred to be present as CeNF under the present experimental conditions. Microstructural observations show that CeNFs are aggregated and present in the pores/cracks between the Al filters in the compressed forms. Al filters and CeNF aggregates were more finely mixed when the material was fabricated into hot extruded plates with a higher extrusion ratio. The maximum tensile strength of the CeNF/Al composite extruded plate was about 1.5 times higher than pure aluminum. In addition, the extruded plates could be cold-rolled by about 30%, and the maximum tensile strength of the extruded sheets was found to be about twice that of pure aluminum. Pracoviště Ústav přístrojové techniky Kontakt Martina Šillerová, sillerova@ISIBrno.Cz, Tel.: 541 514 178 Rok sběru 2023 Elektronická adresa https://www.jstage.jst.go.jp/article/matertrans/63/11/63_MT-M2022107/_article
Počet záznamů: 1