Počet záznamů: 1
Optically-transparent oxide fibre-reinforced glass matrix composites
- 1.
SYSNO ASEP 0355562 Druh ASEP J - Článek v odborném periodiku Zařazení RIV J - Článek v odborném periodiku Poddruh J Článek ve WOS Název Optically-transparent oxide fibre-reinforced glass matrix composites Tvůrce(i) Desimone, D. (GB)
Dlouhý, Ivo (UFM-A) RID, ORCID
Lee, W. E. (GB)
Koch, D. (DE)
Horvath, J. (DE)
Boccaccini, A. R. (GB)Zdroj.dok. Journal of Non-Crystalline Solids. - : Elsevier - ISSN 0022-3093
Roč. 356, 44-49 (2010), s. 2591-2597Poč.str. 7 s. Jazyk dok. eng - angličtina Země vyd. NL - Nizozemsko Klíč. slova fracture toughness ; glas matrix composites ; light transmittance Vědní obor RIV JH - Keramika, žáruvzdorné materiály a skla CEP GA101/09/1821 GA ČR - Grantová agentura ČR CEZ AV0Z20410507 - UFM-A (2005-2011) UT WOS 000285282100058 DOI 10.1016/j.jnoncrysol.2010.05.015 Anotace Development of ‘optomechanical composites’, based on glass matrices reinforced with continuous oxide fibre bundles (Nextel™) or filaments (sapphire) is described. The fibres were arranged unidirectionally between soda-lime silicate or borosilicate glass slides, and heat-treated to achieve densification by viscous flow of the glass matrix between the fibres. Small decreases in light transmittance (up to approximately 20%) upon introduction of fibres was indicated. Fibre pull-out and crack deflection were identified at fibre/matrix interfaces, and a crack bridging effect was observed, with fibres holding the glass pieces together, thus preventing catastrophic failure. A relatively low fibre/matrix interfacial sliding resistance was measured by the fibre push-in test, although flexural strength measurements indicated the need to improve interfacial bonding. Pracoviště Ústav fyziky materiálu Kontakt Yvonna Šrámková, sramkova@ipm.cz, Tel.: 532 290 485 Rok sběru 2011
Počet záznamů: 1