0491887 - ÚFM 2019 RIV CH eng J - Článek v odborném periodiku
Král, Petr - Dvořák, Jiří - Sklenička, Václav - Masuda, T. - Horita, Z. - Kuchařová, Květa - Kvapilová, Marie - Svobodová, M.
The Effect of Ultrafine-Grained Microstructure on Creep Behaviour of 9% Cr Steel.
Materials. Roč. 11, č. 5 (2018), č. článku 787. ISSN 1996-1944. E-ISSN 1996-1944
Grant CEP: GA ČR(CZ) GA16-09518S
Institucionální podpora: RVO:68081723
Klíčová slova: high-pressure torsion * severe plastic-deformation * martensite ferritic steels * fe2w laves phase * long-term creep * strengthening mechanisms * precipitation behavior * resistant steels * room-temperature * 9cr steels * creep-resistant 9% Cr steels * ultrafine grained materials * creep * electron back scatter diffraction
Obor OECD: Materials engineering
Impakt faktor: 2.972, rok: 2018 ; AIS: 0.608, rok: 2018
DOI: https://doi.org/10.3390/ma11050787

The effect of ultrafine-grained size on creep behaviour was investigated in P92 steel. Ultrafine-grained steel was prepared by one revolution of high-pressure torsion at room temperature. Creep tensile tests were performed at 873 K under the initially-applied stress range between 50 and 160 MPa. The microstructure was investigated using transmission electron microscopy and scanning electron microscopy equipped with an electron-back scatter detector. It was found that ultrafine-grained steel exhibits significantly faster minimum creep rates, and there was a decrease in the value of the stress exponent in comparison with coarse-grained P92 steel. Creep results also showed an abrupt decrease in the creep rate over time during the primary stage. The abrupt deceleration of the creep rate during the primary stage was shifted, with decreasing applied stress with longer creep times. The change in the decline of the creep rate during the primary stage was probably related to the enhanced precipitation of the Laves phase in the ultrafine-grained microstructure.
Trvalý link: http://hdl.handle.net/11104/0286827