Počet záznamů: 1
VLBI receiver chain monitoring
- 1.
SYSNO ASEP 0396960 Druh ASEP C - Konferenční příspěvek (mezinárodní konf.) Zařazení RIV D - Článek ve sborníku Název VLBI receiver chain monitoring Tvůrce(i) Michálek, V. (CZ)
Kodet, J. (CZ)
Schreiber, U. (DE)
Ploetz, Ch. (DE)
Procházka, I. (CZ)
Pánek, Petr (URE-Y) RIDCelkový počet autorů 6 Zdroj.dok. Proceeding 2013 Joint European Frequency and Time Forum and International Frequency Control Symposium, EFTF/IFC 2013. - Praha : IEEE, 2013 - ISBN 9781479903429 Rozsah stran s. 854-856 Poč.str. 3 s. Forma vydání Nosič - C Akce 2013 Joint UFFC, EFTF and PFM Symposium Datum konání 21.07.2013-25.07.2013 Místo konání Prague Země CZ - Česká republika Typ akce WRD Jazyk dok. eng - angličtina Země vyd. CZ - Česká republika Klíč. slova Frequency standards ; Calibration ; Two-way time transfers Vědní obor RIV JA - Elektronika a optoelektronika, elektrotechnika Institucionální podpora URE-Y - RVO:67985882 EID SCOPUS 84893263213 DOI 10.1109/EFTF-IFC.2013.6702153 Anotace he most demanding goal of the Global Geodetic Observing System initiative is the definition of station positions to an accuracy of 1mm and the corresponding velocities to 0.1 mm/year. The main remaining sources of error are caused by systematics, leading to intra- and inter- technique biases. In this work, we have focused on Very Long Base Interferometry (VLBI) and phase calibration generator currently in operation. This unit is injecting calibration tones into the detection chain through an input coupler located near the input of the antenna. The tones propagate further through entire detection chain and are recorded with the observed signal. Then they are extracted in post processing. These tones are generated out of an atomic frequency standard. The supplied frequency is significantly influenced by temperature and mechanical changes since usually a long cable is employed to bring the frequency to the calibration unit. To monitor the electrical length of the cable, calibration with a picosecond precision is essential. We have redesigned a phase calibration unit so that it enables the implementation of the Two Way Time Transfer (TWTT) method on single coaxial cable using two event timers to monitor the electrical length of the critical cable. Such a system has been installed in parallel to the unit currently in operation. The comparison of the TWTT method with previous measurement method is presented Pracoviště Ústav fotoniky a elektroniky Kontakt Petr Vacek, vacek@ufe.cz, Tel.: 266 773 413, 266 773 438, 266 773 488 Rok sběru 2014
Počet záznamů: 1