Electronic and mechanical response of graphene on BaTiO.sub.3./sub. at martensitic phase transitions

0580117 - FZÚ 2024 RIV US eng J - Článek v odborném periodiku
Verhagen, Timotheus - Valeš, V. - Kalbáč, M. - Vejpravová, Jana
Electronic and mechanical response of graphene on BaTiO₃ at martensitic phase transitions.
Journal of Physics-Condensed Matter. Roč. 30, č. 8 (2018), č. článku 085001. ISSN 0953-8984. E-ISSN 1361-648X
Grant CEP: GA ČR(CZ) GA15-01953S
Institucionální podpora: RVO:68378271
Klíčová slova: BaTiO₃ * graphene * stain * phase transition
Obor OECD: Condensed matter physics (including formerly solid state physics, supercond.)
Impakt faktor: 2.711, rok: 2018
Způsob publikování: Omezený přístup
https://doi.org/10.1088/1361-648X/aaa8b7

In our work, we report on changes of strain and doping in graphene grown by chemical vapor deposition on copper and transferred onto a BaTiO3(1 0 0) (BTO) single-crystal. The BTO is known as a ferroelectric material, which undergoes several thermoelastic martensitic phase transitions when it is cooled from 300 K to 10 K. In order to enhance the very weak Raman signal of the graphene monolayer (ML) on the BTO, a 15 nm thin gold layer was deposited on top of the graphene ML to benefit from the surface enhanced Raman scattering. Using temperature dependent Raman spectral mapping, the principal Raman modes (D, G and 2D) of the graphene ML were followed in situ. From a careful analysis of these Raman modes, we conclude that the induced strain and doping of the graphene ML follows the martensitic phase transitions of the BTO crystal. Our study suggests potential exploitation of the graphene as a highly sensitive opto-mechanical sensor or transducer.
Trvalý link: https://hdl.handle.net/11104/0348887