Manufacturing parameter influence on FDM polypropylene tensile properties

0577550 - ÚFM 2024 RIV KR eng J - Článek v odborném periodiku
Milovanović, A. - Golubovic, Z. - Kirin, S. - Babinský, Tomáš - Šulák, Ivo - Milošević, M. - Sedmak, A.
Manufacturing parameter influence on FDM polypropylene tensile properties.
Journal of Mechanical Science and Technology. Roč. 37, č. 11 (2023), s. 5541-5547. ISSN 1738-494X. E-ISSN 1976-3824
GRANT EU: European Commission(XE) 857124 - Horizont 2020
Institucionální podpora: RVO:68081723
Klíčová slova: Additive manufacturing parameters * Anova * Fused deposition modeling * Polypropylene
Obor OECD: Materials engineering
Impakt faktor: 1.6, rok: 2022
Způsob publikování: Omezený přístup
https://link.springer.com/article/10.1007/s12206-023-2305-5

Polypropylene (PP) is a relatively new material in fused deposition modeling (FDM) technology. The main feature of this material is its ability to significantly elongate under applied load, unlike any other thermoplastic material used in FDM technology. Not much research has been conducted on this FDM material so far, hence, the subject of this paper is the investigation of printing parameters’ influence on PP tensile properties. Targeted parameters are layer height, infill density, and the orientation of raster lines, resulting in four different manufacturing regimes. To have a better insight into the experimental results, the data are analysed using ANOVA statistical method with Tukey HSD post hoc test. Obtained statistical results have proven the printing parameter’s influence on tensile results, emphasizing the influence on elastic modulus. Here, Tukey test results show the maximal number of homogeneous subsets evidencing that all printing parameters have an influence on elastic modulus values.
Trvalý link: https://hdl.handle.net/11104/0346668