High Cycle Fatigue Behaviour of 316L Stainless Steel Produced via Selective Laser Melting Method and Post Processed by Hot Rotary Swaging

0574218 - ÚFM 2024 RIV CH eng J - Článek v odborném periodiku
Opěla, P. - Benč, Marek - Kolomý, Š. - Jakůbek, Zdeněk - Beranová, Denisa
High Cycle Fatigue Behaviour of 316L Stainless Steel Produced via Selective Laser Melting Method and Post Processed by Hot Rotary Swaging.
Materials. ROČ. 16, č. 9 (2023), č. článku 3400. E-ISSN 1996-1944
Institucionální podpora: RVO:68081723
Klíčová slova: 316L steel * selective laser melting * hot compression testing
Obor OECD: Materials engineering
Impakt faktor: 3.4, rok: 2022
Způsob publikování: Open access
https://www.mdpi.com/1996-1944/16/9/3400

This paper deals with a study of additively manufactured (by the Selective Laser Melting, SLM, method) and conventionally produced AISI 316L stainless steel and their comparison. With the intention to enhance the performance of the workpieces, each material was post-processed via hot rotary swaging under a temperature of 900 degrees C. The samples of each particular material were analysed regarding porosity, microhardness, high cycle fatigue, and microstructure. The obtained data has shown a significant reduction in the residual porosity and the microhardness increase to 310 HV in the sample after the hot rotary swaging. Based on the acquired data, the sample produced via SLM and post-processed by hot rotary swaging featured higher fatigue resistance compared to conventionally produced samples where the stress was set to 540 MPa. The structure of the printed samples changed from the characteristic melting pools to a structure with a lower average grain size accompanied by a decrease of a high fraction of high-angle grain boundaries and higher geometrically necessary dislocation density. Specifically, the grain size decreased from the average diameters of more than 20 mu m to 3.9 mu m and 4.1 mu m for the SLM and conventionally prepared samples, respectively. In addition, the presented research has brought in the material constants of the Hensel-Spittel formula adapted to predict the hot flow stress evolution of the studied steel with respect to its 3D printed state.
Trvalý link: https://hdl.handle.net/11104/0344587