Enhanced tribological performance and nanostructuring speed on AlTiN by beamshaping technology

0570991 - FZÚ 2024 RIV GB eng J - Článek v odborném periodiku
Primus, T. - Hauschwitz, Petr - Vítů, T. - Bičišťová, Radka - Zeman, P. - Cimrman, Martin - Brajer, Jan - Mocek, Tomáš - Smrž, Martin
Enhanced tribological performance and nanostructuring speed on AlTiN by beamshaping technology.
Surface Engineering. Roč. 38, č. 10-12 (2022), s. 939-947. ISSN 0267-0844. E-ISSN 1743-2944
Grant CEP: GA MŠMT EF15_006/0000674; GA MŠMT LO1602
GRANT EU: European Commission(XE) 739573 - HiLASE CoE
Grant ostatní: OP VVV - HiLASE-CoE(XE) CZ.02.1.01/0.0/0.0/15_006/0000674
Institucionální podpora: RVO:68378271
Klíčová slova: Beamshaping * friction * micromachining * functionalization * laser * AlTiN * lipss
Obor OECD: Optics (including laser optics and quantum optics)
Impakt faktor: 2.8, rok: 2022
Způsob publikování: Open access

For the first time,a dynamic beamshaping technology has been utilized for the efficient production of periodic nanostructures on top of AlTiN coating to enable dry machining without costly and environmentally hazardous cutting fluids.First,a variety of periodic nanostructures with periods in a range of 740–273nm were produced utilizing different wavelengths. Additionally, beamshaping technology increased productivity by 4008% up to 105cm2 min−1 by shaping the Gaussian beam into a rectangular beam of 500 × 30 µm.To simulate the application load and resulting heat production during manufacturing,friction analysis was performed at room and elevated temperature to 500°C.The analysis revealed a significant reduction in the friction coefficient – up to 27% and 19% at room temperature and 500°C, respectively.The combination of these results demonstrates that the proposed method can be scaled up for the mass production of functionalized machining tools for dry machining.
Trvalý link: https://hdl.handle.net/11104/0342886