Počet záznamů: 1
Mechanical analysis of the rotating drawing mandrel with selected bearings configuration
- 1.0538830 - ÚGN 2021 RIV RS eng J - Článek v odborném periodiku
Botko, F. - Hatala, M. - Botková, Dominika - Radchenko, S.
Mechanical analysis of the rotating drawing mandrel with selected bearings configuration.
STED Journal. Roč. 2, č. 2 (2020), s. 9-12. ISSN 2637-2150. E-ISSN 2637-2614
Institucionální podpora: RVO:68145535
Klíčová slova: forming * tube * mandrel * bearing * stress
Obor OECD: Mechanical engineering
Způsob publikování: Open access
http://stedj-univerzitetpim.com/wp-content/uploads/2020/12/Mechanical-analysis-of-the-rotating-drawing-mandrel-with-selected-bearings-configuration.pdf
Nowadays is important to increase power efficiency in the heat production sector. Tubes with shaped internal surface are one of the possibilities to improve efficiency of heat exchangers. In the fact of
this is actual to look on the improvements of the process of forming from the perspective of the tool construction. Presented article is focused on mechanical analysis of the rotating mandrel for cold
forming of tubes with shaped internal surface. As a proposed material of the tool was selected heat-treated tool steel. Analyses were performed with selected configuration of the bearings. One bearing
was configured as radial and second bearing was configured as radial-axial. A result shows stresses in the mandrel and deformation of the mandrel under a load of forming pressure. Obtained results have potential to enhance knowledge in the area of construction of the forming tools.
Trvalý link: http://hdl.handle.net/11104/0316545
Název souboru Staženo Velikost Komentář Verze Přístup UGN_0538830.pdf 3 278.6 KB Jiná povolen
Počet záznamů: 1