Design of printed circuit board production using water jet technology

0517680 - ÚGN 2020 RIV RS eng J - Článek v odborném periodiku
Gajdovčík, P. - Lehocká, Dominika - Dupláková, D. - Botko, F. - Sitek, Libor
Design of printed circuit board production using water jet technology.
TEM Journal - Technology, Education, Management, Informatics. Roč. 8, č. 4 (2019), s. 1313-1318. ISSN 2217-8309. E-ISSN 2217-8333
Grant CEP: GA MŠMT(CZ) LO1406
Institucionální podpora: RVO:68145535
Klíčová slova: printed circuit boards * water jet * conductive pattern * hole * proposal
Obor OECD: Mechanical engineering
Způsob publikování: Open access
http://www.temjournal.com/content/84/TEMJournalNovember2019_1313_1318.pdf

Printed circuit boards are part of electronic devices and affect the functioning of today's society. At present, printed circuit boards are manufactured for relatively long periods of time using the same methods. The presented article focuses on the design of the possibility which eliminates errors arising from the development and etching of PCBs. It describes the theoretical design of the use of hydrodynamic continuous water jet machining in PCB production. The proposal points to the possibility of using positive water jet properties are as such: no heat-affected zone, thin separation gap, absence of dust particles and toxic fumes.
Trvalý link: http://hdl.handle.net/11104/0302999