Extrapolation of bulk rock elastic moduli of different rock types to high pressure conditions and comparison with texture-derived elastic moduli

0490796 - GLÚ 2019 RIV NL eng J - Článek v odborném periodiku
Ullemeyer, K. - Lokajíček, Tomáš - Vasin, R.N. - Keppler, R. - Behrmann, J. H.
Extrapolation of bulk rock elastic moduli of different rock types to high pressure conditions and comparison with texture-derived elastic moduli.
Physics of the Earth and Planetary Interiors. Roč. 275, FEB 2018 (2018), s. 32-43. ISSN 0031-9201. E-ISSN 1872-7395
Grant CEP: GA ČR GA13-13967S; GA ČR(CZ) GA16-03950S
Institucionální podpora: RVO:67985831
Klíčová slova: anisotropy * calcite * crystallography * elastic moduli * elasticity * extrapolation * marble * neutron diffraction * rock pressure * seismic waves * Shear waves * single crystals * structural geology * velocity
Obor OECD: Geology
Impakt faktor: 2.615, rok: 2018

In this study elastic moduli of three different rock types of simple (calcite marble) and more complex (amphibolite, micaschist) mineralogical compositions were determined by modeling of elastic moduli using texture (crystallographic preferred orientation, CPO) data, experimental investigation and extrapolation. 3D models were calculated using single crystal elastic moduli, and CPO measured using time-of-flight neutron diffraction at the SKAT diffractometer in Dubna (Russia) and subsequently analyzed using Rietveld Texture Analysis. To define extrinsic factors influencing elastic behaviour, P-wave and S-wave velocity anisotropies were experimentally determined at 200, 400 and 600 MPa confining pressure. Functions describing variations of the elastic moduli with confining pressure were then used to predict elastic properties at 1000 MPa, revealing anisotropies in a supposedly crack-free medium. In the calcite marble elastic anisotropy is dominated by the CPO. Velocities continuously increase, while anisotropies decrease from measured, over extrapolated to CPO derived data. Differences in velocity patterns with sample orientation suggest that the foliation forms an important mechanical anisotropy. The amphibolite sample shows similar magnitudes of extrapolated and CPO derived velocities, however the pattern of CPO derived velocity is closer to that measured at 200 MPa. Anisotropy decreases from the extrapolated to the CPO derived data. In the micaschist, velocities are higher and anisotropies are lower in the extrapolated data, in comparison to the data from measurements at lower pressures. Generally our results show that predictions for the elastic behavior of rocks at great depths are possible based on experimental data and those computed from CPO. The elastic properties of the lower crust can, thus, be characterized with an improved degree of confidence using extrapolations. Anisotropically distributed spherical micro-pores are likely to be preserved, affecting seismic velocity distributions. Compositional variations in the polyphase rock samples do not significantly change the velocity patterns, allowing the use of RTA-derived volume percentages for the modeling of elastic moduli.
Trvalý link: http://hdl.handle.net/11104/0284936