Shot peening as a pre-treatment to anodic oxidation coating process of AW 6082 aluminum for fatigue life improvement

0479875 - ÚFM 2018 RIV GB eng J - Článek v odborném periodiku
Hadzima, B. - Nový, F. - Trško, L. - Pastorek, F. - Jambor, M. - Fintová, Stanislava
Shot peening as a pre-treatment to anodic oxidation coating process of AW 6082 aluminum for fatigue life improvement.
International Journal of Advanced Manufacturing Technology. Roč. 93, 9-12 (2017), s. 3315-3323. ISSN 0268-3768. E-ISSN 1433-3015
Grant CEP: GA MŠMT(CZ) LQ1601
Institucionální podpora: RVO:68081723
Klíčová slova: Fatigue life * AW 6082 aluminum alloy * Anodizing * Shot peening * Ultrasonic fatigue testing
Obor OECD: Audio engineering, reliability analysis
Impakt faktor: 2.601, rok: 2017
https://link.springer.com/content/pdf/10.1007%2Fs00170-017-0776-1.pdf

Shot peening with glass beads was used as a pretreatment to anodic oxidation of AW 6082 aluminum alloy to eliminate the negative effect of the anodized layer on fatigue strength. Shot peening with intensity 6N and coverage of 100% was able to significantly improve the fatigue strength of the experimental material and when N = 3 × 109 cycles is considered the fatigue strength increased from sigma a = 80 MPa to sigma a = 110 MPa. Creation of the anodized surface layer with thickness of approximately 30 micrometers on the pre-treated surface decreased the fatigue strength, when compared to the shot peened surface, almost in the whole measured region, however, the fatigue strength was still higher than for not treated material. The positive effect of shot peening on fatigue strength was a result of creation of compressive residual stress field with maximum of - 200 MPa and depth of 350 micrometers. Fracture surface analysis showed that this deformed surface layer had increased resistance to fatigue crack initiation and propagation in the early stages and cracks created on the anodized surface layer were unable to propagate directly to the material and new initiation of fatigue crack was required, however, it was still accelerated by the sharp notch which the crack created.
Trvalý link: http://hdl.handle.net/11104/0278863