Temperature dependence of Young's modulus of silica refractories

0472845 - ÚSMH 2017 RIV GB eng J - Článek v odborném periodiku
Gregorová, E. - Černý, Martin - Pabst, W. - Esposito, L. - Zanelli, C. - Hamáček, J. - Kutzendorfer, J.
Temperature dependence of Young's modulus of silica refractories.
Ceramics International. Roč. 41, č. 1 (2015), s. 1129-1138. ISSN 0272-8842. E-ISSN 1873-3956
Institucionální podpora: RVO:67985891
Klíčová slova: mechanical properties * elastic modulus (Young's modulus) * SiO2 * Silica brick materials (cristobalite, tridymite)
Kód oboru RIV: JH - Keramika, žáruvzdorné materiály a skla
Impakt faktor: 2.758, rok: 2015

The temperature dependence of Young's modulus of silica refractories exhibiting pore volume fractions in the range 18.6-20.9% is investigated via impulse excitation up to 800-1000 degrees C and four-point bending up to 500 degrees C. This temperature dependence exhibits a broad valley approximately below 200 degrees C, where Young's modulus values decrease to 55-62% of their room temperature magnitude. Upon further heating, Young's modulus increases steeply within a few degrees around 230 degrees C, followed by an S-shaped increase to maximum values corresponding to 174-282% of the room temperature values. Cooling branches are different from heating branches and do not form closed loops, indicating damage accumulation. Dilatation measurements, polarization microscopy, micromechanical calculations and X-ray phase analysis are used to underpin the conclusion that the observed elastic effects are not caused by phase transitions alone, but are combined effects of phase transitions and microcrack opening and partial closure. (C) 2014 Elsevier Ltd and Techna Group S.r.l. All rights reserved.
Trvalý link: http://hdl.handle.net/11104/0270064