Spark plasma versus conventional sintering in the electrical properties of Nasicon-type materials

0464859 - ÚTAM 2017 RIV NL eng J - Článek v odborném periodiku
Pérez-Estébanez, Marta - Isasi-Marín, J. - Rivera-Calzada, A. - León, C. - Nygren, M.
Spark plasma versus conventional sintering in the electrical properties of Nasicon-type materials.
Journal of Alloys and Compounds. Roč. 651, December (2015), s. 636-642. ISSN 0925-8388. E-ISSN 1873-4669
Grant CEP: GA MŠMT(CZ) LO1219
Klíčová slova: electrode materials * ionic conduction * sintering
Kód oboru RIV: BF - Elementární částice a fyzika vys. energií
Impakt faktor: 3.014, rok: 2015
http://www.sciencedirect.com/science/article/pii/S0925838815308227

Li1+xMxTi2-x(PO4)3 powders with x = 0 and 0.3 and M = Al, Cr and Fe have been sintered by conventional sintering (CS) and Spark Plasma Sintering (SPS), and the electrical properties have been compared. The use of SPS allows preparing samples with higher density at lower temperature and shorter time than the CS, avoiding segregation of secondary phases and with reduced crystallite size. The introduction of aluminum, chromium and iron in the LiTi2(PO4)3 (LTP) clearly enhances ionic conductivity even if the samples have similar densities. Despite the different level of density reached with CS and SPS, the activation energies of dc and grain boundary contributions are very similar and the differences in ionic conductivity are determined by pre-exponential factors. The samples produced by SPS showed a well-defined grain boundary meaning a more homogenous electrical contact.
Trvalý link: http://hdl.handle.net/11104/0263616