Effect of stress-induced anisotropy on the noise of ring-core fluxgate

0448911 - FZÚ 2016 RIV US eng J - Článek v odborném periodiku
Butta, M. - Ripka, P. - Kraus, Luděk
Effect of stress-induced anisotropy on the noise of ring-core fluxgate.
IEEE Transactions on Magnetics. Roč. 51, č. 1 (2015), s. 4001104. ISSN 0018-9464. E-ISSN 1941-0069
Grant CEP: GA ČR GAP102/12/2177
Institucionální podpora: RVO:68378271
Klíčová slova: anisotropy * fluxgate * nanocrystalline * noise * permalloy
Kód oboru RIV: JB - Senzory, čidla, měření a regulace
Impakt faktor: 1.277, rok: 2015

In this paper, we show how an anisotropy perpendicular to the direction of excitation is favorable to obtain low noise in fluxgate sensors. We produced ring cores by electroplating NiFe thin film (6 μ m) over a bended copper substrate. After the electroplating process, the sample was released and back-stress-induced anisotropy in the magnetic film due to magnetostriction of the material. As a result, we obtained rings with regions showing hard behavior and orthogonal regions showing soft behavior. Then, we used such rings as core for fluxgate and measured both noise and sensitivity for different orientation of the ring in the pick-up coil. When the pick-up coil covers the area with anisotropy perpendicular to the direction of excitation, the sensitivity is lower due to lower permeability, but finally, the noise is lower. On the other hand, rotating the core by 90°, the anisotropy becomes parallel to the direction of excitation and thus the sensitivity increases.
Trvalý link: http://hdl.handle.net/11104/0250520