Geomechanical parametres of the Podlesí granites and their relationship to seismic velocities

0371598 - ÚSMH 2012 RIV CZ eng J - Článek v odborném periodiku
Nováková, Lucie - Sosna, K. - Brož, Milan - Najser, J. - Novák, P.
Geomechanical parametres of the Podlesí granites and their relationship to seismic velocities.
Acta geodynamica et geomaterialia. Roč. 8, č. 3 (2011), s. 353-369. ISSN 1214-9705. E-ISSN 2336-4351.
[Czech-Polish Workshop on Recent Geodynamics of the Sudeten and Adjacent Areas. Třešť, 04.11.2010-06.11. 2010]
Grant CEP: GA MPO(CZ) FR-TI1/367
Výzkumný záměr: CEZ:AV0Z30460519
Klíčová slova: granite * porosity * seismic waves
Kód oboru RIV: DB - Geologie a mineralogie
Impakt faktor: 0.530, rok: 2011
http://www.irsm.cas.cz/abstracts/AGG/03_11/17_Novakova%20.pdf

We studied the geophysical, physical, and geomechanical parameters of the Podlesí granites in the western part of the Krušné hory Mts., near the village of Potůčky. The granites represent a fractionated intrusion within the Nejdecký Massif. In total, the studied borehole is about 300 m deep. The samples were collected at depths of between 35 and 105 metres. Seismic P-wave and S-wave velocities were measured using ultrasonic scanning. The samples were water-saturated, unsaturated, and dried. The ultrasonic scanning system consisted of four piezoelectric sensors and a digital oscilloscope recorder. The wave frequency was 1 MHz. P-wave velocities range from 4400 m.s-1 to 6500 m.s-1 while S-wave velocities range from 2800 m.s-1 to 3800 m.s-1. These data were used to calculate dynamic Young’s modulus, dynamic shear modulus, and Poisson’s ratio. The deformational characteristics of the rock were specified from experimental loading of the sample with uniaxial strain. The shear and longitudinal deformation of each sample was measured using a resistive strain gauge fixed directly on the sample. Intermittent loading of the samples proceeded using a uniform gradient of axial stress of 1 MPa.s-1. The samples were subjected to five separate loads. During the tests, following parameters were recorded: stress, longitudinal deformation, and shear deformation. These data were used to calculate static Young’s and shear modulus, and Poisson’s ratio.
Trvalý link: http://hdl.handle.net/11104/0205076