Neutron and X-ray Diffraction Analysis of Macro and Phase-Specific Micro Residual Stresses in Deep Rolled Duplex Stainless Steels

0542592 - ÚJF 2022 RIV CH eng J - Journal Article
Pulvermacher, S. - Bucker, T. - Šaroun, Jan - Rebelo-Kornmeier, J. - Hofmann, M. - Gibmeier, J.
Neutron and X-ray Diffraction Analysis of Macro and Phase-Specific Micro Residual Stresses in Deep Rolled Duplex Stainless Steels.
Materials. Roč. 14, č. 8 (2021), č. článku 1854. E-ISSN 1996-1944
R&D Projects: GA ČR GC16-08803J
Institutional support: RVO:61389005
Keywords : residual stress measurement * phase specific stress * macro stress * phase-specific micro residual stresses * duplex steel * neutron diffraction
OECD category: Materials engineering
Impact factor: 3.748, year: 2021
Method of publishing: Open access
https://doi.org/10.3390/ma14081854

Experimental analyses of depth distributions of phase-specific residual stresses after deep rolling were carried out by means of laboratory X-ray diffraction and neutron diffraction for the two duplex steels X2CrNiMoN22-5-3 and X3CrNiMoN27-5-2, which differ significantly in their ferrite to austenite ratios. The aim of the investigation was to elucidate to which extent comparable results can be achieved with the destructive and the non-destructive approach and how the process induced phase-specific micro residual stresses influence the determination of the phase- and {hkl}-specific reference value d(0), required for evaluation of neutron strain scanning experiments. A further focus of the work was the applicability of correction approaches that were developed originally for single-phase materials for accounting for spurious strains during through surface neutron scanning experiments on coarse two-phase materials. The depth distributions of macro residual stresses were separated from the phase-specific micro residual stresses. In this regard, complementary residual stress analysis was carried out by means of incremental hole drilling. The results indicate that meaningful macro residual stress depth distributions can be determined non-destructively by means of neutron diffraction for depths starting at about 150-200 mu m. Furthermore, it was shown that the correction of the instrumental surface effects, which are intrinsic for surface neutron strain scanning, through neutron ray-tracing simulation is applicable to multiphase materials and yields reliable results. However, phase-specific micro residual stresses determined by means of neutron diffraction show significant deviations to data determined by means of lab X-ray stress analysis according to the well-known sin(2)psi-method.
Permanent Link: http://hdl.handle.net/11104/0319978