Effect of glass forming additives on low-activity waste feed conversion to glass

0585973 - ÚSMH 2025 RIV NL eng J - Journal Article
Vernerová, Miroslava - Šůsová, K. - Kohoutková, M. - Kloužek, Jaroslav - Cincibusová, Petra - Ferkl, P. - Marcial, J. - Kruger, A.A. - Pokorný, Richard
Effect of glass forming additives on low-activity waste feed conversion to glass.
Journal of Nuclear Materials. Roč. 593, MAY (2024), č. článku 155003. ISSN 0022-3115. E-ISSN 1873-4820
Institutional support: RVO:67985891
Keywords : Glass melting * Glass-forming additives * Nuclear waste * Vitrification
OECD category: Ceramics
Impact factor: 3.1, year: 2022
Method of publishing: Limited access
https://doi.org/10.1016/j.jnucmat.2024.155003

A significant effort was invested in the past to develop and refine mathematical models that relate the composition of nuclear waste glasses with their properties, such as viscosity, electrical conductivity, or chemical durability. However, less attention has been paid to the formulation of the melter feed itself, such as the chemical form and the particle size of the glass forming and modifying additives, which have a significant effect on the feed-to-glass conversion process during melting. To address this issue, we systematically changed the mineral composition of a simulated low-activity waste melter feed and inspected its melting behavior. When substituting minerals with corresponding oxides and hydroxides, we found that different alumina sources (kyanite, gibbsite, boehmite, or corundum) had the strongest effect on the feed melting process, whereas the sources of Ca, Mg, and Zr had little effect. The X-ray diffraction analysis showed that the alumina sources differ in their dissolution kinetics: early dissolving alumina sources, such as gibbsite (Al(OH)3) and boehmite (AlO(OH)), increase the transient glass-forming melt viscosity at early stages, when gases still evolve, causing extended foaming, whereas alumina sources that dissolve at high temperatures, such as kyanite (Al2SiO5) and corundum (Al2O3), keep the transient glass-forming melt viscosity low and lead to a faster foam collapse. Using a viscosity-composition relationship to estimate the viscosity of transient glass-forming melts in the primary foaming range, we found that the primary foam began to collapse at 360 to 800 Pa s, and fully collapsed between 65 and 260 Pa s. This result agrees with our previous studies, according to which, the glass-forming melt viscosity at the cold cap foam bottom ranged from 24 to 85 Pa s.
Permanent Link: https://hdl.handle.net/11104/0353628