CFD simulation of a small bubble motion in 3D flow domain: effect of liquid density, viscosity and surface tension

0572618 - ÚCHP 2024 RIV DE eng J - Journal Article
Crha, Jakub - Basařová, P. - Růžička, Marek
CFD simulation of a small bubble motion in 3D flow domain: effect of liquid density, viscosity and surface tension.
Chemical Papers. Roč. 77, č. 7 (2023), s. 3979-3992. ISSN 0366-6352
R&D Projects: GA ČR(CZ) GA19-09518S
Institutional support: RVO:67985858
Keywords : single rising bubble * level set method * conservative * surface tension * two-phase flow
OECD category: Chemical process engineering
Impact factor: 2.2, year: 2022
Method of publishing: Open access
https://link.springer.com/article/10.1007/s11696-023-02758-8

The motion of spherical and slightly deformed bubbles rising rectilinearly in a stagnant liquid was numerically simulated in a fully three-dimensional domain using the CFD solver COMSOL Multiphysics. The interface was tracked by the built-in conservative Level set method on a fixed numerical grid. The purpose of this work was to study the single bubble motion in three industrially used liquids that differ significantly in surface tension, density, and viscosity. The motion of bubbles with diameters up to 1.6 mm was also studied experimentally using a high-speed camera. The data obtained together with the results of theoretical models for bubble motion were used for the validation of the simulation data. Using a 3D domain, very good agreement was obtained in both bubble shape deformations and bubble terminal velocity. The best results were achieved for propanol with low surface tension and low viscosity. In the case of high surface tension and low viscosity liquid (water), both the bubble deformation and the bubble velocity were slightly underestimated. In the case of glycerol (high surface tension and viscosity), the negligible bubble deformation is correctly calculated, but the velocity is again slightly underestimated.
Permanent Link: https://hdl.handle.net/11104/0343308