Influence of High Pressure Sliding and Rotary Swaging on Creep Behavior of P92 Steel at 500 ◦C

0549844 - ÚFM 2022 RIV CH eng J - Journal Article
Král, Petr - Dvořák, Jiří - Sklenička, Václav - Horita, Z. - Takizawa, Y. - Tang, Y. - Kunčická, Lenka - Kvapilová, Marie - Oháňková, M.
Influence of High Pressure Sliding and Rotary Swaging on Creep Behavior of P92 Steel at 500 ◦C.
Metals. Roč. 11, č. 12 (2021), č. článku 2044. E-ISSN 2075-4701
R&D Projects: GA ČR(CZ) GA19-18725S
Institutional support: RVO:68081723
Keywords : creep-resistant steels * severe plastic deformation * creep behavior
OECD category: Materials engineering
Impact factor: 2.695, year: 2021
Method of publishing: Open access
https://www.mdpi.com/2075-4701/11/12/2044

High-pressure sliding (HPS) and rotary swaging (RS) at room temperature were used to form severely deformed microstructures in martensitic creep-resistant P92 steel. The deformed microstructures contained markedly different ratios of low- and high-angle grain boundaries (LAGBs/HAGBs). The application of the RS method, with an imposed equivalent strain of 1.4, led to the
formation of a heterogeneous microstructure with a high number of LAGBs, while the HPS method, with an imposed equivalent strain of 7.8, led to the formation of a relatively homogeneous ultrafine-grained microstructure with a significant predominance of HAGBs. Microstructure analyses after creep testing showed that the microstructure of RS- and HPS-processed P92 steel is quite stable, but a slight coarsening of subgrains and grains during creep testing can be observed. Constant load tensile creep tests at 500 ◦C and initial stresses ranging from 300 to 900 MPa revealed that the specimens processed by HPS exhibited higher creep strength (slower minimum creep rate) and ductility compared to the coarse-grained and RS-processed P92 steel. However, the HPS-processed P92 steel also exhibited lower values of stress exponent n than the other investigated states of P92 steel. For this reason, the differences in minimum creep rates determined for different states decrease with decreasing values of applied stress, and at applied stresses lower than 500 MPa, the creep resistance of the RS-processed state is higher than the creep resistance of the HPS-processed state.
Permanent Link: http://hdl.handle.net/11104/0326890