The Use of Areal Parameters for the Analysis of the Surface Machined Using the Abrasive Waterjet Technology

0494137 - ÚGN 2020 RIV CH eng C - Conference Paper (international conference)
Klichová, Dagmar - Klich, Jiří - Zlámal, T.
The Use of Areal Parameters for the Analysis of the Surface Machined Using the Abrasive Waterjet Technology.
Advances in Manufacturing Engineering and Materials. Basel: Springer Nature Switzerland AG 2019, 2019 - (Hloch, S.; Klichová, D.; Krolczyk, G.; Chattopadhyaya, S.; Ruppenthalová, L.), s. 36-44. Lecture Notes in Mechanical Engineering, 1. ISBN 978-3-319-99353-9. ISSN 2195-4356.
[International Conference on Manufacturing Engineering and Materials (ICMEM 2018). Nový Smokovec (SK), 18.06.2018-22.06.2018]
R&D Projects: GA MŠMT(CZ) LO1406
Institutional support: RVO:68145535
Keywords : surface topography * abrasive waterjet * areal parameters
OECD category: Materials engineering
https://link.springer.com/chapter/10.1007/978-3-319-99353-9_5

The paper deals with areal evaluation of the surface texture of AISI 304 material created by the abrasive waterjet. The sample examined was measured using an optical profilometer and an optical microscope. The surface topography is most frequently evaluated according to the surface profile parameters defined in ISO 4287. However, for a more complex analysis of a studied surface, it is more advantageous to use an areal (three-dimensional) method which applies the knowledge acquired from the profile (two-dimensional) method extended by new research findings. The areal parameters of the surface texture are described in the standard ISO 25178-2.
Permanent Link: http://hdl.handle.net/11104/0287395