Počet záznamů: 1

Influence of Variously Modified Surface of Aluminium Alloy on the Effect of Pulsating Water Jet

SYSNO ASEP	0482313
Druh ASEP	J - Článek v odborném periodiku
Zařazení RIV	J - Článek v odborném periodiku
Poddruh J	Článek ve WOS
Název	Influence of Variously Modified Surface of Aluminium Alloy on the Effect of Pulsating Water Jet
Tvůrce(i)	Klich, Jiří (UGN-S)_{RID, ORCID} Klichová, Dagmar (UGN-S)_{RID, ORCID} Foldyna, Vladimír (UGN-S) Hlaváček, Petr (UGN-S)_{RID, ORCID} Foldyna, Josef (UGN-S)_{RID, ORCID}
Celkový počet autorů	5
Zdroj.dok.	Strojniski Vestnik-Journal of Mechanical Engineering - ISSN 0039-2480 Roč. 63, č. 10 (2017), s. 577-582
Poč.str.	6 s.
Forma vydání	Online - E
Jazyk dok.	eng - angličtina
Země vyd.	SI - Slovinsko
Klíč. slova	pulsating water jet ; surface topography ; material erosion
Vědní obor RIV	JQ - Strojní zařízení a nástroje
Obor OECD	Mechanical engineering
CEP	FV10446 GA MPO - Ministerstvo průmyslu a obchodu
	LO1406 GA MŠMT - Ministerstvo školství, mládeže a tělovýchovy
	ED2.1.00/03.0082 GA MŠMT - Ministerstvo školství, mládeže a tělovýchovy
Institucionální podpora	UGN-S - RVO:68145535
UT WOS	000413204700004
DOI	10.5545/sv-jme.2017.4356
Anotace	Erosion effects of a pulsating water jet impinging the surface of aluminium alloy samples pre-treated by various techniques (rough and fine milling, planing and rolling) were studied. The influence of the initial surface topography on the final topography of the sample exposed to the pulsating water jet was investigated. Based on roughness parameter Ra erosion of surface layers was analysed and discussed in relation to the traversing speed of the jet. It was found that initial surface pre-treatment have a significant impact on the final topography of the surface affected subsequently by pulsating water jet. Surfaces, whose properties are significantly affected by the action of some machining processes (i.e. milling) show much greater resistance to pulsating water jet than unpaved surfaces (i.e. rolling) and surfaces have smaller roughness. While milled (rough or fine) or planed surface roughness has approximately the same increase of Ra parameter, only rolled surfaces are up to 150 times rougher after pulsating water jet treatment. This is due to the small hardening of the surface layers and reduced durability against pulsating water jet in comparison with others investigated techniques. The highest roughness was achieved on all pre-treated surfaces at the lowest speeds, because the pulsating water jet affects the surface for a longer time.
Pracoviště	Ústav geoniky
Kontakt	Lucie Gurková, lucie.gurkova@ugn.cas.cz, Tel.: 596 979 354
Rok sběru	2018
Elektronická adresa	http://ojs.sv-jme.eu/index.php/sv-jme/article/view/sv-jme.2017.4356

Počet záznamů: 1