0603486 - FZÚ 2025 RIV US eng J - Článek v odborném periodiku
Federičová, Pavla - Affolder, A. - Beck, G.A. - Bevan, A.J. - Klein, Ch. - Kroll, Jiří - Latoňová, Věra - Mikeštíková, Marcela - Miyagawa, P.S. - O'Toole, S. - Tůma, Pavel - Ullan, M. - Unno, Y. - Zenz, S.C. … celkem 30 autorů
Setups for eliminating static charge of the ATLAS18 strip sensors.
Journal of Instrumentation. Roč. 19, č. 2 (2024), č. článku C02001. ISSN 1748-0221. E-ISSN 1748-0221
Grant CEP: GA MŠMT(CZ) LTT17018; GA MŠMT LM2023040; GA MŠMT(CZ) LM2018104
Institucionální podpora: RVO:68378271
Klíčová slova: particle tracking detectors * solid state detectors
Obor OECD: Particles and field physics
Impakt faktor: 1.3, rok: 2023 ; AIS: 0.425, rok: 2023
Způsob publikování: Open access
DOI: https://doi.org/10.1088/1748-0221/19/02/C02001

Construction of the new all-silicon Inner Tracker (ITk), developed by the ATLAS collaboration to be able to track charged particles produced at the High-Luminosity LHC, started in 2020 and is expected to continue till 2028. The ITk detector will include 18,000 highly segmented and radiation hard n+-in-p silicon strip sensors (ATLAS18), which are being manufactured by Hamamatsu Photonics. Mechanical and electrical characteristics of produced sensors are measured upon their delivery at several institutes participating in a complex Quality Control (QC) program. The QC tests performed on each individual sensor check the overall integrity and quality of the sensor. During the QC testing of ATLAS18 strip sensors, an increased number of sensors that failed the electrical tests was observed. In particular, IV measurements indicated an early breakdown, while large areas containing several tens or hundreds of neighbouring strips with low interstrip isolation were identified by the Full strip tests, and leakage current instabilities were measured in a long-term leakage current stability setup. Moreover, a high surface electrostatic charge reaching a level of several hundreds of volts per inch was measured on a large number of sensors and on the plastic sheets, which mechanically protect these sensors in their paper envelopes. Accumulated data indicates a clear correlation between observed electrical failures and the sensor charge-up. To mitigate the above-described issues, the QC testing sites significantly modified the sensor handling procedures and introduced sensor recovery techniques based on irradiation of the sensor surface with UV light or application of intensive flows of ionized gas. In this presentation, we will describe the setups implemented by the QC testing sites to treat silicon strip sensors affected by static charge and evaluate the effectiveness of these setups in terms of improvement of the sensor performance.
Trvalý link: https://hdl.handle.net/11104/0360813