Young’s modulus of different illitic clays during heating and cooling stage of firing

0539287 - ÚFP 2021 RIV CH eng J - Článek v odborném periodiku
Húlan, T. - Štubňa, J. - Ondruška, J. - Csáki, Štefan - Lukáč, František - Mánik, M. - Vozár, L. - Ozolins, J. - Kaljuvee, T. - Trník, A.
Young’s modulus of different illitic clays during heating and cooling stage of firing.
Materials. Roč. 13, č. 21 (2020), s. 1-14, č. článku 4968. E-ISSN 1996-1944
Institucionální podpora: RVO:61389021
Klíčová slova: Clay * Illite * Quartz * Thermal expansion * Young’s modulus
Obor OECD: Materials engineering
Impakt faktor: 3.623, rok: 2020
Způsob publikování: Open access
https://www.mdpi.com/1996-1944/13/21/4968

Dynamical thermomechanical analysis of 5 illite-based clays from deposits in Slovakia, Estonia, Latvia, and Hungary is presented. The clays consist of illite (37–80 mass%), quartz (12–48 mass%), K-feldspar (4–13 mass%), kaolinite (0–18 mass%), and calcite (0–3 mass%). Young’s modulus is measured during the heating and cooling stages of firing (25◦C → 1100◦C → 25◦C). The liberation of the physically bound water increases Young’s modulus by ∼70% for all studied clays. By increasing the temperature, dehydroxylation and the α → β transition of quartz take place without a significant effect on Young’s modulus. Sintering, which starts at 800◦C, leads to an intensive increase in Young’s modulus up to the highest temperature (1100◦C). The increase remains also in the early stage of cooling (1100◦C → 800◦C). This increase of Young’s modulus is also the result of solidification of the glassy phase, which is finished at ∼750◦C. A sharp minimum of Young’s modulus is observed at around the β → α transition of quartz. Then, Young’s modulus still decreases its value down to the room temperature. The physical processes observed during heating and cooling do not differ in nature for the studied clays. Values of Young’s modulus vary at around 8 GPa, up to 800◦C. During sintering, Young’s modulus reaches values from 30 GPa to 70 GPa for the studied clays. The microstructure and composition given by the origin of the clay play a cardinal role for the Young’s modulus of the final ceramic body.
Trvalý link: http://hdl.handle.net/11104/0316976